Welcome to Dimensional Metals, Inc.

Span-Lock SL25

Span-Lock SL20

Inter-Lock IL20

Double-Lock DL15

Snap-On-Seam SS10

Snap-One-Seam SS15

Batten-Seam BS15

Nail-Strip NS10 & NS15

Flush-Panel FP10

V-Groove VS05

Curved-Radius CR

Tapered Seam (TS) &
Compound Curve (CC)

Wall Panels (WP)

Horizontal Wall Panel HWP16

Miscellaneous Panel Details

SNAP-ON-SEAM HIGH PROFILE SS15

Details | Specifications | Submittal
SS15

PRODUCT: SNAP-ON-SEAM SS15 is a non-structural engineered snap-together panel system. The system is designed with two components: the panel pan and the seam cover. SNAP-ON-SEAM is a non-directional panel system allowing installers more control during installation over seam layout and symmetry of the panel area. SNAP-ON-SEAM is the easiest panel system to install over difficult roof plans.

PRODUCT USES AND APPLICATIONS: PProduct uses include roofing with roof slopes as low as 3:12, vertical fascia, mansards and equipment screens. This system may be installed on curved (radii greater than 70 ft.) or tapered roof areas.

ROOF ASSEMBLIES: SNAP-ON-SEAM requires a solid substrate since it is a non-structural panel system. This system may be installed over plywood sheathing, nail base insulation, or corrugated metal deck.

ADVANTAGES:

UL-90 classified assemblies: high wind uplift loading capacities
ASTM Air and Water Infiltration Tested: proven air and water tightness
Optional Factory Applied Non-Curing Sealant: superior watertightness
Engineered Snap-Together Design: easy installation
Expansion Clips: allows for unlimited thermal expansion and contraction
Continuous Interlocking Seam: no seam disengagement
Anti-Siphoning Seam Design: prevents water infiltration
Continuous Rollformed Lengths: eliminates need for panel lap joints

STANDARD PRODUCT OFFERING
24 ga. and .032 Aluminum:

MODEL NO.		SEAM ON-CENTER
SS1512 SS1516 SS1518		12" 16" 18"

16 oz. and 20 oz. Copper:

MODEL NO.		SEAM ON-CENTER
SS1512 SS1518		12" 18"

OPTIONAL PRODUCT OFFERING
SNAP-ON-SEAM SS20 (2" high seam) - NO UL90 RATING
24 ga. and .032 Aluminum:

MODEL NO.		SEAM ON-CENTER
SS2012 SS2018		12" 18"

Custom panel widths are available. Consult DMI for costs and lead times.

NOTE:Continuous lengths from 2’-6” (min.) up to 70’-0" (max.) is standard. Panel lengths over 53’ require additional crating fees and special hauling permits. Contact DMI for details.

22 ga. steel and .040 aluminum are not stocked in all colors. Minimum order quantities and extended lead times may accompany panel orders when utilizing these substrates

Seam caps are available in 24 Ga. Steel, .032 Aluminum, and 16 oz. copper only.

Oil-canning, the slight waviness inherent with light gauge metal, does not affect the finish or structural integrity of the panel and is therefore not cause for rejection.

See front for optional stiffener patterns.

(Contact DMI for Load Capacities)